toefu
Guest
I'm trying to wire my workhorse 7 for 2x110watt VHO. For some strange reason, it does not seem as bright as i believe it should. My 2x250watt 10k MH's just completely drown them out and you can't even notice the actinic at all. Mh's are always 6 inches above surface water and no actinic at all.
I took the 2 out of 4 red wires and merged them into 1 wire.
Took the other 2 and merged into 1 wire.
connected each of these wires to 1 end of each VHO
took the single yellow wire and split into 2 wires, connected each splitted end to the other ends of the vho bulbs. They do fire up, but just don't seem too bright.
I know reef alot uses workhorse 7 as well as other marshers, so just seeing if i did it right or not.
I took the 2 out of 4 red wires and merged them into 1 wire.
Took the other 2 and merged into 1 wire.
connected each of these wires to 1 end of each VHO
took the single yellow wire and split into 2 wires, connected each splitted end to the other ends of the vho bulbs. They do fire up, but just don't seem too bright.
I know reef alot uses workhorse 7 as well as other marshers, so just seeing if i did it right or not.