Okay, so this morning it is nice and rainy in Houston. I leave to work and maybe 20 minutes out I get a notification that the tank cam was disconnected. I knew this was likely due to the power going out. So a few minutes later I turn on the app to check the cam just to see if the power had been restored. Of course the power is back on already but now my DC return pump is at full blast. This happens each time if there is a power failure. So now that the pump has been on max blowing tons of microbubbles in the tank and dumped all the fresh water from the ato into the sump, I have to make a call so someone can rush back to the apt to make sure everything is ok and to readjust the return pump flow. So, my big question is.... does anyone know how to readjust the setting for when the pump cuts back on when there is a power failure? Only when the power fails and power returns does the pump reset to max power so I need to figure out how to change it or find an alternative return pump so this doesn't continue to happen. If anyone could give me some help or good suggestions I would greatly appreciate it.